How To Make Your Fireplace Heat Up More
No one wants to struggle for a long time to start a fire, be cold, or have to pay more than required for fuel. By increasing your fireplace’s efficiency and heat output, you can prevent all of these issues. Fireplaces may be a wonderful source of heat all winter long in addition to being aesthetically pleasing. Whether you have a wood-burning fireplace or a gas fireplace. Make sure your fireplace is operating as efficiently as possible if you plan to use it for heating.
The fuel is what keeps your fire burning. If you get this wrong, your fire won’t be effective and won’t produce the heat that it is capable of. Make sure you have a supply of suitable wood before moving forward. You see burning wood that is green, damp, moldy, or which has been sprayed or treated can either result in an entirely unsuccessful fire or a fire that burns badly and emits a lot of smoke and particles. On the other side, dry wood burns well, produces little smoke, and generates a lot of heat. Therefore, as a general rule, wood shouldn’t be burned until it has completely dried out.
There is typically a chimney damper on classic fireplaces and chimneys. A damper’s job is to close the chimney when it’s not in use. By doing this, warm air inside your house is kept from escaping. When using a wood-burning fireplace, a lot of heat is typically lost as the smoke ascends the chimney. To avoid this, you’ll need to figure out how to move air away from the area you’re trying to warm so it doesn’t rise. A lower damper is often available on fireplaces so you can accomplish this. Commonly, base dampers enable air to exit the firebox through the base.
Installing a fireback is another technique to increase the efficiency of your fireplace. A fireback is essentially a sheet or panel of metal that rests against the back wall of your fireplace behind the fire, generally made of cast iron. A fireback actively reflects heat from the fire out into your living space, making you feel warmer in addition to safeguarding the bricks of your chimney. Due to the thermal qualities of cast iron, many firebacks will also retain heat and continue to radiate heat into your room even after the fire has gone out or been put out.
Make sure the air in your chimney cavity has warmed up before you begin stacking firewood into your fireplace. Rolling up several sheets of newspaper, lighting it, and holding it at the base of the chimney for a short while are the simple steps for priming a chimney. Forcing out any wet or cold air will enable warm air and smoke to start percolating up the chimney.
It is beneficial to get your chimney cleaned after you’ve been using it for a time. Ideally, you should have your chimney cleaned by an expert Local Chimney Cleaning Service Los Angeles at the start of your burning season (early autumn). Any obstructions or accumulations of soot or creosote in your chimney will prevent your fireplace from working properly. Here, choosing the right wood will pay off. Wet or badly treated wood can emit significant amounts of creosote and other unsavory particulates when burned, but properly seasoned wood would emit relatively little creosote.