Factors Why Your Fireplace Does Not Start On Fire

Even in southern states where winter is still present, a fireplace may be required for warmth before spring arrives and stays into the summer. But what if you find that you are suddenly unable to kindle a fire? There are numerous reasons why a fire in a fireplace won’t ignite.

You can have some problems starting a fire if your wood isn’t sufficiently dry. If your wood isn’t completely dry, the moisture it still contains prevents the fire from becoming hot enough. Greenwood, or too-wet wood, uses the heat of the fire to burn out the excess moisture. However, the wetness may also make it harder for the wood to reach the necessary temperature for a spark to ignite. Additionally, if you try to light wet or green wood, you might only get a lot of smoke instead of enough fire to heat the chimney and move the smoke up and away from the house. It matters what kind of wood you burn in the fireplace. The wood needs to be adequately dried and seasoned. Otherwise, the wood has too much moisture and any flames that do start would provide far less heat than a fire made with seasoned wood.

Your chimney’s damper is the plate or valve that controls or interrupts the airflow there. The ventilation in your home is a key factor in how well your chimney works. It’s possible that something has happened that stops the damper in your fireplace from fully opening, even if you remembered to do so. There are numerous potential causes for why the damper won’t open properly, ranging from water damage to soot buildup behind the dampers. Typically, all that is required to solve the problem is to hire a qualified Local Chimney Cleaning Fiddletown.

For it to work, your fireplace needs fuel. That means gas, of course, for gas fireplaces. Of course, a gas supply is necessary for a gas fireplace to work. There could be a number of causes for the absence of fire gas. It may have been turned off and just needs to be turned back on. There is typically a wall switch or a valve close to the fireplace that transfers the gas from the main line or source to the fireplace. The gas supply may still be present but the line may be open, or possibly a utility payment was missed in the mail, and the gas was turned off.

The pilot light going out is one of the most typical problems we encounter with gas fireplaces. This may occur if a quick downdraft or wind knocked out the pilot light. A quick downdraft or wind might extinguish the pilot light in a gas fireplace. The pilot light should be turned back on if this is what happened. A pilot light is typically lit by turning the control knob counterclockwise to the Pilot position. The pilot should be lit when you press the red button. Turn the knob to the “on” position after holding the button in for roughly a minute.

Differences Between Prefabricated Fireplaces and Masonry Fiddletown
How to Prevent Drafts in a Fireplace Fiddletown