Check the Thermopile
Begin at the top of the thermopile. The thermopile and the thermocouple are both temperature sensors, however the thermopile really has a larger electrical current than the thermocouple does. In this step, you are going to require a multimeter, which is an instrument that examines the TH/TP connections in order to determine the quantity of energy that is being generated. Make certain that the pilot light has been on for at least two minutes before beginning the test, but turn it off before you do so.
Find the thermopile sensor with electric connections that are labeled TH/TP and TP, and then bring it over to the main gas control valve. If you run into any problems, the instruction booklet provided by the manufacturer will be of use to you. A reading of less than 300 millivolts on your multimeter indicates that the thermopile most likely needs to be cleaned, therefore aim to get that reading up to at least 300.
Turning off the gas supply and cleaning the thermopile using a tiny brush made of stainless steel and sandpaper with a fine grit may be accomplished with relative ease. Utilize your multimeter once again to obtain an additional reading. If the temperature has not increased, you will need to replace the thermopile.
Make sure the thermocouple is accurate.
If the reading on the thermopile is accurate, you should then concentrate on the thermocouple. To obtain a reading on the thermocouple using your multimeter, use the instrument to obtain a reading that is at least 25 millivolts. If the temperature falls below this threshold, the thermocouple will need to be replaced.
Check the Ports on the Burner.
Check the ports on the burners as the last step. In the same way as the thermopile, the burner ports are susceptible to becoming filthy and clogged. In this particular case, the flame of the pilot light becomes erratic or fails to ignite at all. It’s possible that using an air duster to clean the burner ports will fix the issue with your gas fireplace.
The Fire in Your Gas Fireplace Cannot Be Kept Alight.
Have you examined, cleaned, and/or replaced all of the appropriate parts, yet your gas fireplace continues to turn off even after you use it? It’s possible that your gas fireplace is experiencing one or more of these frequent issues:
Gas valve: despite the fact that gas fireplaces are risk-free, they nonetheless contain functioning elements that have the potential to malfunction with usage and age. If you’ve been using the gas valve for a significant amount of time, there’s a remote possibility that it may malfunction in such a way. In order to locate and repair a defective gas valve, you will need to get the assistance of a trained specialist.
Gas line: the drip loop can fail due to moisture in the gas line, which might be another plausible explanation why your gas fireplace won’t remain lit. Another potential cause is that your gas fireplace was installed incorrectly. Natural gas and moisture don’t go well together since one will dilute the other. For the proper diagnosis and treatment of this issue, you will require the assistance of a trained specialist.
Gas pressure: there may be an issue with the gas pressure provided by your service provider. If it is not adjusted correctly, the pilot light on your gas fireplace will continue to go out. Both a fireplace specialist and your utility provider will need to be contacted in order to resolve this issue successfully.
All these reminders are best practiced when you are also assured of having a reliable company at your side. Contact Local Chimney Sweep Cleaning today for Chimney Cleaning El Cerrito and repairing.