Fireplace Does Not Work

It is now winter, with thick snowflakes falling to the ground and a brisk wind blowing through the bare trees. You’ve got the fire going in the fireplace, the mugs of hot chocolate are ready to go, and the only thing left to do is switch on the fireplace. Because it runs on gas, there is very little physical exertion required, which contributes to the overall pleasantness of the winter season. Then, you become aware that the light is not turning on.

What should you do if the fireplace in your home is broken? Don’t worry about it; we’ve got you covered in every way.

Does the remote control for your fireplace run on batteries?
Before you dismiss this initial idea out of hand, give some thought to Occam’s Razor, which states that the answer that is most likely the solution to a problem is the answer that is the simplest. If you turn the gas fireplace on or off using a remote control or receiver, there is a significant probability that the batteries are dead and need to be changed. If this is the case, try using a different set of batteries.

It’s possible that your batteries have been mistreated, or if you’re like the majority of people, you could still be using the batteries that came with your device since you haven’t given replacement batteries any attention. In either case, you should check up on them at this point in time.

malfunction of the fireplace caused by a tripped circuit
Even in brand-new homes, there is always the possibility of a tripped circuit. When electrical wire is subjected to an excessive amount of energy current flowing through it, the breakers get overloaded and trip, which cuts off the flow of power in an effort to prevent the circuit from being overheated.

Is it possible that this is the issue with your fireplace? You will easily be able to determine whether something tripped the circuit breaker since the switch will be switched to the “on” position, but there will not be an indication light. Head to your circuit breaker box to analyze the situation. After turning it on and off again to reset the breaker, you might think about reducing the number of electrical devices that are dependent on that specific circuit breaker.

Concerns Regarding the Thermocouple and Thermopile Found in Your Fireplace
A thermocouple is a sensor made of metal that warms up when it comes into direct contact with the flame of your pilot light. These sensors are typically found on newly manufactured fireplaces, and their function is to determine the temperature of the fireplace so that the gas may be ignited if it is required.

Alternately, a thermopile is a temperature sensor that generates electric voltage and, when activated by the flip of a switch, allows the gas valve to be opened. Although these components are built into fireplaces to make their usage more convenient, they also have the potential to be the cause of a fireplace’s inability to function properly.

To address the issue at hand, as you can see, you are going to need a level of expertise and experience that is above and beyond that of the typical do-it-yourselfer. In the event that you are having issues with either your thermocouple or your thermopile, it is advised to call in the experts.

If you suspect that your chimney or fireplace is having some issues, have an expert inspect it. Call Local Chimney Sweep Cleaning today. We also offer Chimney Cleaning Oakley and other affordable services.

Chimney Without Liner Oakley
Getting Sick From a Dity Chimney Oakley