The Installation of a Chimney Cap

What is the typical price range for installing a chimney cap?
There is a wide range of variety in terms of the sizes, forms, materials, and finishes available for chimney caps. Copper, galvanized metal, and stainless steel are the three most common materials used in the construction of chimney tops. Installation of a standard-sized single flue cover can cost anywhere from $175 to $225, depending on the size of the cap. Stainless steel chimney caps are often more expensive. The price of installing a Multi-Flue cap can range anywhere from $1,100 to more than that depending on the material, finish, size, and any specialized equipment that is necessary to install the chimney top.

Instructions for Putting on a Chimney Cap

1. Take dimensions of the chimney.
2. Obtain a chimney top that has a diameter that corresponds with the size of the flue.
3. Determine if your chimney cover is meant to be installed or may be slipped over the top of the flue.
4. Screw the top into place.
5. Provide that there is a distance of at least six inches between the top of the cap and the flue in order to ensure adequate ventilation.
6. Drill pilot holes in the top of the chimney cover for the self-tapping screws, and then insert them.
7. Fasten the chimney cover securely to the top of the flue.

Instructions for Putting up a Chimney Cap With Multiple Flues

1. Take a measurement of the overall height as well as the breadth of the flues.
2. Measure the height of the chimney crown along the side that is the longest.
3. Obtain a chimney cap that has the appropriate dimensions to cover the crown and flues of the chimney.
4. Using a brush or something like, remove any debris that may be found on the crown.
5. Position the chimney cap so that it covers the flues and rests on the top of the chimney.
6. Provide that there is a distance of at least six inches between the top of the cap and the flue in order to ensure adequate ventilation.
7. Using a masonry bit that is 1/8 of an inch smaller in diameter than the screws you will be using, drill pilot holes in the chimney crown.
8. Create a wavy bead of caulk that is one inch wide and goes all the way around the crown’s edge.
9. Secure the chimney top to the crown with the screws.
10. Ensure that the pilot holes and the holes in the chimney top are aligned with one another.
11. Using screws, fasten the chimney cover to the crown of the chimney.
12. Check to see that the chimney cover has been correctly attached and is secure on all sides.

Chimney Cap Installation without a Flue: Step-by-Step Instructions
If the chimney is made of masonry, the base for the chimney cap must be in the shape of a terra cotta tile on the crown, and if the chimney is made of metal, the base must be in the form of a circular pipe.

Chimney Cap Installation Instructions for a Round Cap
Clay pot flue tiles and circular chimney caps made of clay are often fitted atop masonry chimneys and metal chimneys respectively. Round chimney tops made of metal will either glide into place or be secured with pressure screws. A bead of silicone sealant is applied to the margins of the cap after it has been put into the flue of a masonry chimney that has round clay pot tiles for the liners.

How Much Time Does It Take to Put a Chimney Cap on a Chimney?
Once a technician is on the roof, the installation of a basic chimney cover with a single flue takes around five to ten minutes. Depending on the design of the chimney cap, installing a multi-flue chimney cap might take anywhere from one hour to more than two hours.

If you have any concern or inquiries but is not sure you can call Local chimney Sweep Cleaning to help you. We also offer professional Chimney Cleaning Douglas Flat and repairing.

Learn About These Chimney Parts Douglas Flat
Various Options for Fireplace Inserts Douglas Flat